DS215KLDCG1AZZ03B

KLDCG1 & FW

Product DESCRIPTION

Part Number

DS215KLDCG1AZZ03B

Manufacturer

General Electric

Country of Manufacture

As Per GE Manufacturing Policy

Series

Mark VI/VIe

Function

Module

Availability

In Stock

services we provide

Testing & Repair

Repair and Testing of circuit boards to diagnose ensure functionality to maintain current inventory and retain obsolete circuit boards/modules.

Training

Controls including HMI Training for Engineers, Technicians and Operators with wide variety of practical equipment including Management and Health & Safety.

Purchase

You upgrade equipment and we purchase your surplus inventory to maximize the value of unused or end of life assets.

TECHNICAL SPECIFICATIONS FOR GE - DS215KLDCG1AZZ03B

DS215KLDCG1AZZ03B is a Power Connect Board developed by GE. It is a part of Mark V Series. The board includes specific firmware that supports its operation and ensures compatibility with other system components. Firmware updates may be necessary to maintain optimal performance. Connectors and Interfaces: Equipped with various connectors, facilitates easy connections to other boards and components within the control system.

Keypad Removal Procedure

Preliminary Steps: If replacing a C revision board, skip directly to board removal.
Remove Bezel and Components: Remove the screws securing the bezel, then take off the bezel, gasket, and overlays.
Remove Keypad Screws: Unscrew the ten inner screws holding the keypad. Avoid removing the outer screws to prevent the unit from falling out of the enclosure. Carefully pry up the keypad from the top.
Disconnect Connections: Lift the keypad and disconnect the lKPL, 2KPL, and 3KPL connectors from the display board.

Keypad Installation Procedure

Reinstall Keypad: Reverse the removal steps, but do not reconnect the lKPL, 2KPL, and 3KPL connections until the new display board is installed.
Display Board Removal Procedure
Access Board Holder: Open the unit to access the plastic board holder.
Release Board Holder: Unlock the two retainer latches of the board holder, then lift and pull out the board holder to access the display board.
Disconnect Connectors: Disconnect the 3PL, lKPL, 2KPL, and 3KPL connectors. Remove the display board held by six plastic clips.

Display Board Installation Procedure

Install Replacement Board: Place the new board in the board holder, ensuring it is securely held by the plastic clips.
Reconnect Connectors: Reattach the 3PL, lKPL, 2KPL, and 3KPL connectors.
Secure Board Holder: Slide the board holder back into its position and lock it with the two retainer latches.
Close Unit and Test: Close up the unit, restore power, and run the KY/LED/DSP LOCAL MODE UTILITY test to verify the correct installation and operation of the new board.

featured products